Equipment Of Bitumen Extraction From Sand Alberta

Oil sands surface mining. Surface mining is a technique used to obtain bitumen from oil sands where the oil sands deposits are located fairly close to the surface If the reserves are shallow enough, earth moving equipment can dig out oil sand for processing These deposits must be within 75 meters of the surface to be mined in this fashion Resources recoverable by this type of extraction are ...

Equipment Of Bitumen Extraction From Sand Alberta. 202036The tough conditions in oil sands operations require tough solutions. The challenges of moving bitumen and handling viscous liquids with a high solids content at high temperatures require specialied innovative solutions.For bitumen slurry steam condensate and waste water treatment APEX Equipment can keep your operations running

Equipment Of Bitumen Extraction From Sand Alberta. 202036The tough conditions in oil sands operations require tough solutions. The challenges of moving bitumen and handling viscous liquids with a high solids content at high temperatures require specialied innovative solutions.For bitumen slurry steam condensate and waste water treatment APEX Equipment can keep your operations running …

equipment of bitumen extraction from sand alberta. A method for extracting bitumen from crushed mined tar sands comprising contacting the mined tar sands with a solvent in the presence of sonic energy in the frequency range of 0 5 to 2 0 kHz Specifically a solvent is first mixed with crushed mined tar sands and the mixture is then formed into a slurry of tar sand suspended in the solvent

Clay minerals in nonaqueous extraction of bitumen from ... 0 .02.20 2 A non-aqueous bitumen extraction process was studied where only toluene and heptane, with no water additions, were used to extract bitumen from two Alberta oil sands ore samples.One sample had a high bitumen ( 3.5 wt.%) and low fines (5.3 wt.% 45 μm) contents, while the other sample had an intermediate bitumen ( 0.5 wt ...

equipment,of bitumen extraction,from sand alberta. Chili 120-150tph Station de concassage mobile de pierre de rivière. Chili 120-150tph Station de concassage mobile de pierre de rivière. Ligne de concassage de minerai de fer du Chili. Papouasie Nouvelle …

About 80% of Alberta's bitumen reserves are too deep to be mined and must be extracted in-place (or in-situ) using steam.Bitumen is heated and pumped out of the ground, leaving most of the solids behind. In-situ extraction has a much smaller footprint than oil sands mining, uses less water, and does not produce a tailings stream.

28-03-2014· Using the IL trioctylammonium oleate ([HN888][Oleate]) at a 1:3 IL:oil sand mass ratio, we were able to achieve bitumen extraction from high grade Alberta oil sands …

The chemistry of Alberta oil sands, bitumens and heavy oils. Petrophysical properties of bitumen from the Upper Devonian Grosmont reservoir, Alberta, Canada. Extraction of hydrocarbons from oil sand using supercritical carbon dioxid. Near-infrared diffuse reflectance analysis of oil sand. more ...

equipment of bitumen extraction from sand alberta. A method for extracting bitumen from crushed mined tar sands comprising contacting the mined tar sands with a solvent in the presence of sonic energy in the frequency range of 0 5 to 2 0 kHz Specifically a solvent is first mixed with crushed mined tar sands and the mixture is then formed into a slurry of tar sand suspended in the solvent

Clay minerals in nonaqueous extraction of bitumen from ... 0 .02.20 2 A non-aqueous bitumen extraction process was studied where only toluene and heptane, with no water additions, were used to extract bitumen from two Alberta oil sands ore samples.One sample had a high bitumen ( 3.5 wt.%) and low fines (5.3 wt.% 45 μm) contents, while the other sample had an intermediate bitumen ( 0.5 wt ...

About 80% of Alberta's bitumen reserves are too deep to be mined and must be extracted in-place (or in-situ) using steam.Bitumen is heated and pumped out of the ground, leaving most of the solids behind. In-situ extraction has a much smaller footprint than oil sands mining, uses less water, and does not produce a tailings stream.

Surface mining is a technique used to obtain bitumen from oil sands where the oil sands deposits are located fairly close to the surface. If the reserves are shallow enough, earth moving equipment can dig out oil sand for processing. These deposits must be within 75 meters of the surface to be mined in this fashion. Resources recoverable by this type of extraction are estimated to be 65 ...

equipment,of bitumen extraction,from sand alberta. Chili 120-150tph Station de concassage mobile de pierre de rivière. Chili 120-150tph Station de concassage mobile de pierre de rivière. Ligne de concassage de minerai de fer du Chili. Papouasie Nouvelle …

equipment of bitumen eand traction from sand alberta equipmentof bitumen extractionfrom sand equipmentof bitumen extractionfrom sand alberta Bitumen The Canadian Encyclopedia The 2 largestknown sources of bitumen in Alberta and 727 Online Oil sands surface mining . New Extraction Technique Could Replace SDSE for Bitumen

The chemistry of Alberta oil sands, bitumens and heavy oils. Petrophysical properties of bitumen from the Upper Devonian Grosmont reservoir, Alberta, Canada. Extraction of hydrocarbons from oil sand using supercritical carbon dioxid. Near-infrared diffuse reflectance analysis of oil sand. more ...

US9169441B2 US13/306,363 US201113306363A US9169441B2 US 9169441 B2 US9169441 B2 US 9169441B2 US 201113306363 A US201113306363 A US 201113306363A US 9169441 B2 US9169441 B2 US 9169441B2 Authority US United States Prior art keywords bitumen oil sands carbon disulfide process oil Prior art date 2008-10-29 Legal status (The legal status is an assumption and is not a legal …

Using the IL trioctylammonium oleate ([HN888][Oleate]) at a 1:3 IL:oil sand mass ratio, we were able to achieve bitumen extraction from high grade Alberta oil sands of ca. 100% with low solids ...

The total water footprint of bitumen extraction and processing from oil sands deposits in Alberta differed greatly depending on the extraction method. We found that 2.8 L of water were required to obtain a liter of bitumen using in situ drilling (Figure 3 ; Table 5 ), while surface mining required 28.5 L of water per liter of bitumen (Figure 4 ).

equipment of bitumen extraction from sand alberta. Oil Sands 101: Process Overview | Oil Sands Magazine. BITUMEN EXTRACTION. The Alberta oil sands hold an estimated 166 billion barrels of recoverable oil, representing over 96% of Canada's total reserves. The method used to extract bitumen from the oil sands depends on the depth of the deposit.

About 80% of Alberta's bitumen reserves are too deep to be mined and must be extracted in-place (or in-situ) using steam.Bitumen is heated and pumped out of the ground, leaving most of the solids behind. In-situ extraction has a much smaller footprint than oil sands mining, uses less water, and does not produce a tailings stream.

Using the IL trioctylammonium oleate ([HN888][Oleate]) at a 1:3 IL:oil sand mass ratio, we were able to achieve bitumen extraction from high grade Alberta oil sands of ca. 100% with low solids ...

Surface mining is a technique used to obtain bitumen from oil sands where the oil sands deposits are located fairly close to the surface. If the reserves are shallow enough, earth moving equipment can dig out oil sand for processing. These deposits must be within 75 meters of the surface to be mined in this fashion. Resources recoverable by this type of extraction are estimated to be 65 ...

Clay minerals such as montmorillonite and kaolinite are considered as fine solids that could adversely affect bitumen extraction from oil sands. Colloidal forces between bitumen and fine clays and between bitumen and bitumen in the presence of montmorillonite …

Bitumen extraction following oil-sand surface mining in the Athabasca region of Alberta, Canada removes plant nutrients but leaves a petrochemical residue, making the coarse tailings (CT) hostile ...

US9169441B2 US13/306,363 US201113306363A US9169441B2 US 9169441 B2 US9169441 B2 US 9169441B2 US 201113306363 A US201113306363 A US 201113306363A US 9169441 B2 US9169441 B2 US 9169441B2 Authority US United States Prior art keywords bitumen oil sands carbon disulfide process oil Prior art date 2008-10-29 Legal status (The legal status is an assumption and is not a legal …

Water-based bitumen extraction technology from mineable oil sands faces major challenges of high water usage and tailings disposal. In the present study, a process for solvent extraction of bitumen from Athabasca oil sands was investigated. In this process, oil sand is mixed with light hydrocarbon solvents, and the solvent–bitumen solution is separated from the mineral solids by centrifugal ...

The total water footprint of bitumen extraction and processing from oil sands deposits in Alberta differed greatly depending on the extraction method. We found that 2.8 L of water were required to obtain a liter of bitumen using in situ drilling (Figure 3 ; Table 5 ), while surface mining required 28.5 L of water per liter of bitumen (Figure 4 ).

In the present study, solvent extraction of bitumen from Xinjiang oil sands was investigated using solvents, such as alkanes, toluene, and chloroform, and mixed solvents, such as n-hexane–ethyl acetate and cyclohexane–methyl ethyl ketone (MEK). The n-heptane asphaltene content in the extracted bitumen was measured by saturate, aromatic, resin, and asphaltene (SARA) analysis, and the ...